|
NEW RINGS
Lighter in weight and other features
Our products are manufactured in America with old-fashioned attention to
quality and detail. You will not find a better product. Military sniper, police
tactical, hunters and precision long-range shooters come to us for products
with exactness. Our mounts and rings have been used to achieve accuracy in
excess of 2000 yards.
Note: the white on the rings is for display only |
|
Farrell Rings are precision CNC machined from a single piece of solid steel or
aluminum. They are a Weaver-type system that will mate with any Mil Spec
Picatinny Mount. When used with the Farrell Scope Mount they are assured to
have a center line with less than .005 inches deviation.
The rings are made in either aluminum or steel. The aluminum is in either black
or clear finish. They are made in either the standard or high height in both
the 1” and 30MM.. Our standard height rings, together with our mount, will
accommodate a scope with a 56mm objective lens.
The new design of Farrell rings are grooved on the inside of the diameter to
reduce weight, but more important it is to make lapping, if necessary, much
easier. In most cases it is not necessary to lap when using Farrell Rings when
the mount has been bedded in properly. Also the scope will set in the radius
much better. The slot in the cap again is for weight reduction and better
clamping.
The Farrell clamp to the rail, we think is second to none. Why? The clamp screw
is very low – directly across the 45 degree angles. This enables the torque to
be applied in such a way to prevent stressing and moving the center line of the
ring.
The clamp is designed to pivot on all surfaces to assure proper contact on the
rail, the ring and the screw. This is accomplished by using a radius on all
points of contact. Even the seat for the clamping screw has a radius to prevent
lock-up of screw to clamp, which would prevent proper torque across the ring to
the rail. Looking at the line drawing will show this feature. This is very
important, especially when different rails might have different dimensions
across the 45 degree angles that all rings mount on (pica tinny or weaver
style).
-
Farrell rings are perfectly matched
-
If 50 in/lbs of torque is used on our mounting screws that is what you get.
-
There are four screw caps.
-
A MATCHED SET -The top of the line Farrell Mount and Rings features a matched
set with one half the standard factory tolerance and matching serial numbers.
The matched set is available by special order only.

|